©Copyright 2008-2009 Marvell®.
All rights reserved.
setup.htm created 17-Feb-2009
Readme File for SETUP.exe v2.22.1.3
Marvell Yukon Ethernet Controller
This file contains
The Virtual Cable Tester(TM) installation package contains
the Marvell Virtual Cable Tester(TM) application.
This README file explains how to install the Virtual Cable
Tester(TM) Package on a machine running Windows 2000,
Windows XP, Windows Server 2003, Windows Vista and 64-bit
extended Windows.
NOTE:
The Marvell Virtual Cable Tester(TM) can only be used with
Windows 2000, Windows XP, Windows Server 2003, Windows Vista
and 64-bit extended Windows. To run Marvell Virtual Cable
Tester(TM) on Windows Vista please turn off the User Account
Control. Select "Control Panel -> User Accounts -> Turn User
Account Control on or off" and uncheck "Use User Account
Control (UAC) to help protect your computer".
To install the Marvell Virtual Cable Tester(TM), the
following file is required:
setup.exe
NOTE:
To install the Marvell Virtual Cable Tester(TM) make sure
that you are logged in as a user with administrative rights.
To install the Marvell Virtual Cable Tester(TM), proceed as
follows:
1. Execute the setup file setup.exe.
2. Follow the instructions of the installation procedure.
If you should encounter any problems with your Marvell
Virtual Cable Tester(TM) Package, please re-read the
instructions above and the documentation supplied with the
operating system carefully.
Additionally refer to your system event log file (using the
Event Viewer) and check it for entries from Marvell Virtual
Cable Tester(TM).
If your particular problem is not listed or the error
persists, please send your system event log file or at least
the event id number and the logging data (as WORDs) of the
entries made by Marvell Virtual Cable Tester(TM) to our
technical support.
For further information please contact support.
*** End of Readme File ***